Ok well I can't take credit for the speedo cluster image...other than cutting it out of the paper it was printed on. I bought it of ebay. The rest is just paint and BMF detail.
I've used several of those Printed Gauge setups from that same eBay seller, I like them the artwork is always sharp and looks like the porotype.
I like to cut out a clear acetate/plastic sheet to overlay the gauges enhances their looks 100% especially if you put some airspace between the gauges and the clear lens. All you need is a "spacer" which is normally the thinnest plastic sheet I have on hand, then "line" the inside of the gauge so the sheet just forms a lip that the clear lens to rest on. Using a lens over the printed gauge takes a little of the shininess off of the gauges and adds some needed depth to them.
Last Edit: May 22, 2020 8:04:53 GMT -5 by skip: Autocorrect
This is a good spot to drop a quick note or ask for help. If you are in a bad mood, this isn't the right spot to drop feelings. Thanks for understanding!
RodBurNeR: omg condensing years of model supply, tools and paints into one three drawer cabinet is tough! just the common use stuff, rest will be in boxes in a closet unless needed. this is rough lol
Sept 28, 2020 23:30:46 GMT -5
krassandbernie: At least you are finally able to do something model related! LOL!
Sept 30, 2020 10:37:45 GMT -5
RodBurNeR: hah! yeah but where to begin? just trying to see what i have and what i need to start. not sure what to work on, just something simple i guess. painting is gonna have to be outside. been there done that
Sept 30, 2020 11:35:26 GMT -5
RodBurNeR: i think i have all the stuff from storage, been putting it away and sorting. the amount of parts is overwhelming lol oh and the unfinished projects too!
Oct 9, 2020 9:35:12 GMT -5
krassandbernie: Do you guys even check the 'recent threads' or 'recent posts' buttons down at the bottom of the main page?
Jan 5, 2021 15:42:37 GMT -5
Mark Moore: I just tend to click on the sections with a new post myself.
Jan 5, 2021 18:26:23 GMT -5
krassandbernie: There was notifications in the 'Resin' section to indicate a new post(s); but no one has seen the several latest posts I made there.
Jan 5, 2021 18:33:56 GMT -5
krassandbernie: You guys missing the other posts I've made in the 'resin' section? I see a couple of you have spotted the Fordor sedan builds by customers I posted; but missed the others.
Jan 6, 2021 13:48:16 GMT -5
RodBurNeR: I check recent posts
Jan 6, 2021 15:11:17 GMT -5
superflekmoonbird: Thanks Paul...they look good. Air temp may be part of it...for comparison some rattle cans (Tamiya) mention 50 degree F and above, Testors Lacquer says 70 degrees..
Jan 24, 2021 18:22:09 GMT -5